For Ethernet configuration, note that the IP-Address / subnet-mask must correspond
with the address space of the subsequent application.
Table 9: IP-Address factory setting
Parameter
Value
IP-Address
192.168.0.1
Subnet mask
255.255.255.0
7.1.2
Parameter - filters
When selecting the filter, consider filter mutual interference,
7.2
Field evaluation
If the field shape of field set 1 has been taught in without a PC using the teach-in push‐
button, SOPAS is generally used to continue the configuration.
This includes the following:
•
Setting of field shapes/sizes and, if applicable, non-programmable field sets
based on the default setting and the setting of response time of the fields
•
Setting of the blanking size and the holding time of the assigned switching outputs
OUT 1 ... OUT 3
7.2.1
Teach-in / Field set selection
For the field evaluation application, it is possible to configure the device as follows
rather than configuring it via SOPAS:
•
Selection of one of 16 field sets, each with 3 fields of the same size nested into
one another, by means of input wiring.
•
Teach-in of the surrounding contour to automatically generate the outer field with
any shape, including more complex shapes, and to deduce the two inner fields.
The field sets are organized by groups into segmented field shapes. The shapes can be
modified, with the default being a rectangle. In the factory setting, the 3 origin-oriented
fields of a set are nested inside one another.
Segmented,
free shape type
Rectangle
Field 1
Field 2
Field 3
0°
180°
90°
Figure 21: Structure of the fields of a field set and possible field shapes
The size of field 2 corresponds to field 1 plus 25%. The size of field 3 corresponds to
field 1 plus 52%.
OPERATION
7
8024231//2019-03-29 | SICK
O P E R A T I N G I N S T R U C T I O N S | TiM781
35
Subject to change without notice
