Operating Instructions
Chapter
10
RFI341
8013171/ZO93/2017-08-08
©
SICK AG
•
Germany
•
All rights reserved
21
Appendi
x
3.5.7 Output format
The reading result (decoded codes) is displayed via selectable physical interfaces. Two
different output formats (telegrams) can be defined for this task, one format for "No
Read" and one for the heartbeat (signalisation of readiness).
Note The output formats can be configured using the SOPAS-ET configuration
software: PROJECT TREE, RFH620, PARAMETER, DATA PROCESSING,
OUTPUT FORMAT
3.5.8 Network / Interface / IOs
All important interfaces for displaying the reading results are available on the RFH620.
Several RFID devices can be connected to each other via the CAN bus in the SICK-
specific CAN-SENSOR network.
The network parameters can be configured using the SOPAS-ET configuration
software: PROJECT TREE, RFH620, PARAMETER, NETWORK / INTERFACE /
IOS, tab pages NETWORK OPTIONS
3.5.9 Data interfaces
The following data interfaces are available on the RFH620:
Data interface
Function
Host interface
(RS-232 or RS-422/485
and Ethernet host port)
¾
Preparation of the reading result for further
processing by the host processor
Auxiliary interface (RS-232
and Ethernet aux port)
¾
Reading diagnosis or host interface monitoring
CAN
¾
Networking several bar code scanners
Table 3-9: data interface function
The data interfaces can be configured using the SOPAS-ET configuration software:
PROJECT TREE, RFH620, PARAMETER, NETWORK / INTERFACE / IOS,
SERIAL
PROJECT TREE, RFH620, PARAMETER, NETWORK / INTERFACE / IOS,
ETHERNET
PROJECT TREE, RFH620, PARAMETER, NETWORK / INTERFACE / IOS, CAN
3.5.10 Digital Inputs
The external sensor for the object triggering (photoelectric reflex switch) and the
incremental encoder, e.g., can be connected to the digital switching inputs.
The digital inputs can be configured using the SOPAS-ET configuration software:
PROJECT TREE, RFH620, PARAMETER, NETWORK / INTERFACE / IOS,
DIGITAL INPUTS
