4
Sender
The triangulation principle is based on distance measurement through angle calcula‐
tion. The device emits a light beam. When the emitted light beam hits an object,
the light beam is reflected on its surface. The light reflected from the object hits the
light-sensitive receiver in the device at an angle that depends on the distance. Based
on the angle between the sending and receiving beam direction, the distance to the
object is determined via triangulation.
3.4.2
Output of measured values and parameterization
The distance determined is transmitted via the IO-Link interface. The analog signal
output converts the distance value into an output signal proportional to the distance.
The device signals via the digital outputs whether parameterizable switching limits and
distance values have been reached.
Measurement, diagnostic and device data can be queried and parameter settings can
be made via the OLED display. The device can be parameterized via the display, the
IO-Link interface and SOPAS ET.
3.5
Setup and dimensions
PWR
Q2/Q
A
Q1
5
6
7
á
8
1
9
4
à
3
2
1
ß
ß
ß
27
(1.06)
50
(1.97)
2x Ø 4.5
(0.18)
12.5
(0.49)
4.5
(0.18)
25.4
(1.00)
1
0
(0
.3
9
)
6
0
(
2
.3
6
)
5
5
.3
(2
.1
8
)
5
0
.8
(2
.0
0
)
Ø
4
.5
(0
.1
8)
3
5
.3
(1
.3
9
)
2
8
.3
(1
.1
1
)
2
5
.8
(1
.0
2
)
3
6
.5
(1
.4
4
)
1
8
.7
(0
.7
4
)
26.3
(1.04)
Ø 0.7
(0.03)
Figure 5: structure and device dimensions, unit: mm (inch), decimal separator: period
1
Fixing holes (M4)
2
Ventilation opening (do not cover)
3
Device zero point (distance = 0 mm)
4
Device cable (length: 300 mm) with male connector, M12, 5-pin, A-coded
5
Center of optical axis, receiver (device type OD2000-350, OD2000-700)
3
PRODUCT DESCRIPTION
14
O P E R A T I N G I N S T R U C T I O N S | OD2000
8026231//2021-11-17 | SICK
Subject to change without notice
