Chapter
4
Operating instructions
LCUR1411
20
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
8011281/TF99/2013-02-28
Mounting
4.3
Mounting the LCUR1411
If necessary, use anti-vibration mounts!
If the permissible values for vibration or shock (vibration resistance 5g, 10- 55Hz as per
IEC 60 068-2-6, shock resistance 10g, 16 ms as per IEC 60 068-2-29) are exceeded,
we recommend the use of anti-vibration mounts (see chapter 9.3 “Accessories”).
Remove transport protection (foam insert) from the housing for the LCUR1411 and
dispose.
Straps with holes for mounting are attached to the outside of the housing of the
LCUR1411 (Dimensions see chapter 9.2 “Dimensional drawing”)
To make mounting easier, undo the four cover screws (see Fig.7,
)
Disconnect PE cable from the clip on the inside of the cover
Remove housing cover
Securely fasten LCUR1411 with four M6 screws (see Fig.7,
) rubber washers and self-
locking nuts
Re-connect PE cable to the clip on the inside of the cover
Re-fasten housing cover using the four cover screws
WARNING
Note
Fig.7: Mounting the
LCUR1411
