ANNEX
7
8024534 / 16UW / 2020-02-26
Operating Instructions | InspectorP Rack Fine Positioning
39
Subject to change without notice
7
Annex
7.1
Parameter
The following table lists all the parameters with description and information for use.
Parameter
Description
Use
Display mode
Space-optimized display (device-
specific).
Function currently not supported.
Restart app
Restart of app in the device.
Restart the app in the event of errors.
Working distance – single
deep [mm]
Working distance – double
deep [mm]
Define measured distance between
the front screen of the device and the
rack with the positioning mark.
Necessary for recalculation of pixels
in millimeters.
When entering the distance, note the
addition of 40
mm:
Measured di40 mm = input
value
Enter values for the Single and
Double deep modes separately. The
displayed parameter value depends
on the switch setting of the
Double
deep
parameter for the Single or
Double deep mode.
Snap single image
Record a single image.
Record an image when setting up the
device. This simplifies
commissioning, as image recording
does not have to be triggered by the
controller.
Selection
Define hole or reflector which is to
be used as the positioning mark.
If several circles are located in the
field of view of the device.
Selection of the correct hole or the
correct reflector as the positioning
mark. Hiding of the non-relevant
image section for several circles
in the image in evaluation mode 9
to 14.
Perform auto gain
Automatically set image brightness to
make the positioning mark as visible
as possible.
When executing Auto-gain, one
positioning mark must be visible. All
other settings must have been made
correctly.
The device records a series of images
and automatically sets the
Gain
factor
parameter. The switch is
automatically deactivated after
successful automated setting of the
gain factor.
Shutter time [µs]
Adjust image brightness via the
illumination time.
The illumination time usually does not
have to be adjusted. However, this
may be necessary for certain special
applications.
Save image in the device
Save the currently visualized image in
the device.
Save a single image in the device for
a short time during commissioning for
later analysis.
