SICK GSE2 Flat Side, Operating Instruction

Page: 6 / 122

1 2 2 1
1
LED indicator green: supply voltage active
2
Receiver: LED indicator yellow: status of received light beam
5 Mounting
Mount sensors (sender and receiver) using suitable mounting brackets (see the SICK
range of accessories). Align the sender and receiver with each other.
The minimum distance between sender and receiver is:
• GSE2F(S)-xxx1xx: 24 mm
• GSE2F(S)-xxx2xx: 72 mm
• GSE2F(S)-xxx5xx: 238 mm
NOTE
Swap the sender and receiver arrangement at every second through-beam photoelec‐
tric sensor and ensure that there is sufficient distance between the through-beam
photoelectric sensors.
Receiver (GE)
Receiver (GE)
Sender (GS)
Sender (GS)
Sender (GS)
Receiver (GE)
Figure 1: Arrangement of several through-beam photoelectric sensors
Note the sensor's maximum permissible tightening torque of 0.1 Nm.
6 Electrical installation
The sensors must be connected in a voltage-free state (U
V
= 0 V). The following informa‐
tion must be observed, depending on the connection type:
4
OPERATING AND STATUS INDICATORS
6 O P E R A T I N G I N S T R U C T I O N | GSE2 Flat Side 8023329.1C14/28.06.2021 | SICK
Subject to change without notice
en