max. 90 Nm
Note the sensor’s maximum permissible tightening torque of 90 Nm.
NOTE
Swap the sender and receiver arrangement at every second photoelectric through-
beam sensor and ensure that there is sufficient distance between the through-beam
photoelectric sensors.
Receiver (GE)
Receiver (GE)
Sender (GS)
Sender (GS)
Sender (GS)
Receiver (GE)
Figure 10: Arrangement of several through-beam photoelectric sensors
5
Electrical installation
The sensors must be connected in a voltage-free state (U
V
= 0 V). The following informa‐
tion must be observed, depending on the connection type:
–
Male connector connection: pin assignment
–
Cable: wire color
Only apply voltage/switch on the voltage supply (U
V
> 0 V) once all electrical connec‐
tions have been established. The green LED indicator lights up on the sensor.
Explanations of the connection diagram (Tables 2 and 3):
Q /
Q
= switching outputs
TI / Test = test input (
)
n. c. = not connected
ELECTRICAL INSTALLATION
5
8021182 | SICK
Subject to change without notice
7
