63
8012707/ZVF9/V2-1/2019-04 | SICK
O P E R A T I N G I N S T R U C T I O N S | GM32
Subject to change without notice
SHUTDOWN
8
4
For GPP probe: Switch off the power supply of the heater.
5
For GMP probe: Switch the purge air supply off and disconnect the purge air hose on the
device flange.
6
Close off the flange on the gas duct with a cover.
8.2
Storage
1
Clean the exterior of all housings, the measuring probe and all further components
including the purge air unit (when fitted)) with damp cleaning cloths. A mild cleaning
agent can be used.
2
Check the desiccant cartridges and replace, if required,
see “Checking and replacing the
desiccant cartridges”, page 50
3
Protect the openings of the SR-unit and the reflector unit from atmospheric influences
(preferably with the transport safety devices, according to
.
4
Pack the GM32 for storage or transport (preferably in the original packing).
5
Store the GM32 in a dry, clean room.
8.3
Environmentally compatible disposal/recycling
The GM32 can be disposed off as industrial waste.
The following subassemblies could contain substances that have to be disposed of
separately:
●
Electronics: Capacitors, rechargeable batteries, batteries.
●
Display: Liquid of LC display.
●
Probes: Probes can be contaminated with pollutants.
▸
Observe relevant local conditions for disposal of industrial waste.
