SICK GLS100, Operating Instructions Manual

Page: 18 / 48

5 Mounting
5.1 Preparation for mounting
1 Select the mounting site for the GLS100 in accordance with the following chapter
"Mounting requirements", page 18 .
2 Mount the GLS100 using the fixing holes.
"Structure and status indicators", page 11
"Accessories", page 44
5.1.1 Mounting requirements
■
Typical space requirement for sensor, see "", page 42 .
■
Comply with technical parameters such as the permitted ambient conditions for
the operation of the sensor (e.g., temperature range, EM interference),
see "Ambi‐
ent data", page 43 .
■
Protect the sensor from direct sunlight.
■
Only affix the sensor using accessories supplied for this purpose -> there are no
screw connections on the sensor.
■
Sensing distance: 100 mm ( ± 30 mm)
The sensing distance is the distance from the front sensor edge (housing edge) to
the ground.
5.1.2 Scope of delivery
The following are included with delivery of the sensor:
• GLS100 grid localization sensor
• 1 quick-start guide
Accessories:
Accessories (e.g., cables, fastening adapters) are only included with delivery if ordered
separately.
5.2 Mounting the sensor
Arrangement over guide track
The GLS100 must be positioned orthogonally to the 2D code to be detected.
To achieve the maximum overspeed, the sensor should be positioned perpendicular to
the direction of travel.
5
MOUNTING
18 O P E R A T I N G I N S T R U C T I O N S | GLS100 8026282/2021-05-26 | SICK
Subject to change without notice