SICK G6 Inox, Operating Instructions Manual

Page: 6 / 99

6
LED indicator yellow: Status of received
light beam
7
LED indicator green: Supply voltage
active
8
Potentiometer: sensitivity adjustment
6
LED indicator yellow: Status of received
light beam
7
LED indicator green: Supply voltage
active
8
Potentiometer: sensitivity adjustment
4 Mounting
Mount sensors (sender and receiver) using suitable mounting brackets (see the SICK
range of accessories). Align the sender and receiver with each other.
< 0.4 Nm
NOTE
Swap the sender and receiver arrangement at every second photoelectric through-
beam sensor and ensure that there is sufficient distance between the through-beam
photoelectric sensors.
Receiver (GE)
Receiver (GE)
Sender (GS)
Sender (GS)
Sender (GS)
Receiver (GE)
Figure 3: Arrangement of several through-beam photoelectric sensors
5 Electrical installation
The sensors must be connected in a voltage-free state (U
V
= 0 V). The following informa‐
tion must be observed, depending on the connection type:
– Male connector connection: pin assignment
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
V
> 0 V) once all electrical connec‐
tions have been established. The green LED indicator lights up on the sensor.
Explanations of the connection diagram (Tables 2 and 3):
Q /
Q
= switching outputs
n. c. = not connected
4
MOUNTING
6
8021852 | SICK
Subject to change without notice