SICK DL100 Pro, Operating Instructions Manual

Page: 40 / 98

Operating instructions Distance measuring device DL100 Pro – RS-422
Operation at the measuring device
40 © SICK AG • Subject to change without notice • 8014753/ZVZ7/2018-03-22
8.4 Change value
1. Use the keys and to select the desired parameter.
2. Push the key . The current value of the parameter is displayed.
The first figure on the left flashes.
3. Push the key to increase the figure. Push the key to reduce the
figure.
4. Push the key to save the figure entered. The next figure flashes.
Push the key to cancel the process.
5. Repeat the steps 3 and 4 until the last figure is saved. The parameter
name is displayed.
6. Push the key until the measured value is displayed again.
Alternatively, you may also wait for a few minutes. The display
automatically switches back to measured value display without
operation of a key.
8.5 Parameter description
8.5.1 Main menu
The measurement value is displayed by default:
Use the
key to get from the measured value display to the display "Level
Bargraph". Use the keys and to browse within the main menu.
Display Description
Measurement
value
Measurement value display in mm
Level
Bargraph
Level display (damping value) as bargraph
Level numeric Level display (damping value) as numeric value
→ Also see page 28, Table 4.
Temperature Display of indoor temperature of the measuring device
Operating hours
counter
Operating hours display
Warnings Display of the pending warnings. When a warning is pending,
the LED PWR flashes orange. When no warnings are pending,
no warnings are displayed.
→
Also see page 77, chapter 12.2, list of possible warn-
ings.
Error Display of the pending warnings. When an error is pending, the
LED PWR flashes red. When no errors are pending, no errors
are displayed.
→
Also see page 78, chapter 12.3, list of possible errors.
Table 7: Main menu