SICK deTem4 LT Muting A/P, Operating Instructions Manual, Page: 78 / 108

11.3.1 Indications when switching on
Overview
Immediately after switching on, all LEDs on the active unit briefly light up.
The diagnostic LEDs, the INFO LED, and the signal lamp indicate the configuration of the device for 3 s.
Active unit
Position of LEDs: see figure 6, page 15
Table 20: Displays on the active unit when switching on
LEDs End cap with inte‐
grated LED Meaning
OSSD INFO Diagnostics LEDs
1 2 3 4 5 6 7 8
Ö
Yellow,
flashes once
o Ö
Yellow, flashes
once
Beam coding, code 1 is configured.
Ö
Yellow,
flashes twice
Ö
/
O
White
Ö
Yellow, flashes
twice
Beam coding, code 2 is configured.
Ö / O
White
Restart interlock is configured.
Ö
/
O
White
o
Exit monitoring is configured.
Ö
/
O
White
Ö
/
O
White
Entry/exit monitoring is configured.
Ö
/
O
White
C1 muting release is configured.
O
Red
Ö Ö
Yellow/
green
o o o o o o o o Ö Ö
Yellow/green
Reset of the configuration to factory
settings is activated,
see "Factory set‐
tings", page 59 .
O
Red
Ö
Green
Ö
Green Device is in configuration mode, see
"Configuration mode", page 60 .
When a function is configured, the
corresponding diagnostic LED
flashes.
o
LED off.
Ö
LED flashes.
O
LED illuminates. Empty cells mean that the LED lights up, flashes, or is off.
After the configuration is indicated, diagnostic LEDs 1 … 8 indicate the alignment quality.
If the configuration was changed, the corresponding diagnostic LEDs flash white for 3 s upon activation.
11
TROUBLESHOOTING
78 O P E R A T I N G I N S T R U C T I O N S | deTem4 LT Muting A/P 8024802/2020-07-17 | SICK
Subject to change without notice