P R O G R A M M I N G T O O L | S I C K
8016223/19SR/2020-11-02
Subject to change without notice
1 2
PGT
PGT-08-S@SOPAS
4
Connecting and programming the encoder
4.1
PGT-08-S hardware
A
A
DATA
A
DATA
B
SET
B
V/R
US
CLK
Z
CLK
Z
GND
1
2
3
No
Description
1
Cable with USB connection for connecting to PC/laptop
2
Spring terminal block (for encoders with a cable outlet)
3
Cable with SUB-D connection (9-pin) for connecting to encoder-specific programming
cables (for encoders with connector)
4.2
Connecting PGT-08-S hardware and encoder/connection to PC
CAUTION
Risk of damage due to incorrect adapter cable!
The programming tool must only be used with the designated adapter cables (
). Other adapter cables are not permitted. Otherwise, this could result in
damage to the programming tool and/or the encoder.
1. Connect the encoder to the associated cable (
2. Connect the cable to the PGT-08-S hardware (
3. Connect the PGT-08-S hardware to your PC using a USB port.
Note:
The USB interface of the PGT-08-S hardware is designed solely for direct connection to
a computer. USB hubs or extensions should not be used.