This
docu
ment
is
co
py
righ
t!
Ever
y
duplication,
ut
ilization or
di
ssemination
m
ust
b
e
authorised
b
y
the
S
ICK
Stegmann
G
mbH.
Subject to change without notice.
Subject to change without notice. 8014342/157W/2019-08-28 - LF
_07
page
8
of
8
Accessories
There are a lot of accessories available for the Rope Length Transmitters. In principle, the devices are
retrofitable with the accessories. Please see the most important accessories below:
rope guide pulley
Retrofitable mounted rope guide pulley allows to change the direction of wire movement
at 0°..180° in the direction of wire and at 360° square to the direction of wire.
Ball joint
The retrofit built-in of a ball joint in the wire end ring facilitate a
movement in different directions.
Stocking
The R ope Length Transmitter w ill be d elivered well p acked an d can be stock ed on a d ry a nd
covered place.
Attention!
Moist stocking places should not be used. Please be sure that there is no condensation.
The relative humidity should favourably be below 65 %.
Further information
The Rope Length Transmitter should only used to his corresponding purpose!
The Rope Length Transmitter must be installed by trained personnel with knowledge of precision engineering!
Observe the professional Safety and Accident Prevention Regulations applicable to your country!
Please do not make or interrupt electrical connections to the device when the voltage is switched on!
A grounding is necessary to grant an undisturbed function at the coupled encoder!
Exceed or fall below of the operating temperature of the device has to be prevented!
Please avoid shock and vibration load!
SICK STEGMANN GmbH
Postfach 1560, D-78156 Donaueschingen
Dürrheimer Straße 36, D-78166 Donaueschingen
Telefon: + 49 771 807-0
nternet:
www.sick.com
Fax:
+ 49 771 807-100
e-mail:
info@sick.
com
O
perating instructions
for
wire draw
mechanism
MRA-F…
measure of ball
Ø12 H11
10
5930Z02-BA:06
