I
9
SIBER
®
WIRELESS MULTICONTROL
DFEVOCTRL08
6 CONFIGURATION
NOTE
To establish the connection of the HRU, see the HRU menu.
NOTE
For an explanation of the index number and the values, see the HRU manual. When a value is not available, the 4
digit value display shows four dashes.
CAUTION
Ensure that the power supply is correctly connected. See 5.2.1.
6.1. ESTABLISH THE LINK
5.4. START-UP
6.2 SERVICE MENU AND CHANGING SETTINGS
6.2.1. GO TO THE SERVICE MENU
1. Tap the MENU button repeatedly to run through the menus.
2. Tap the Accept button when the link icon appears. The link starts to flash.
3. Tap the Accept button again. The device connects to the HRU automatically.
a. If the link is made correctly, the screen displays BND.
b. If the link is not made correctly, the screen displays NO BND.
4. Tap the BACK button to return to the configuration menu.
5. Tap the BACK button again to exit the configuration menu.
The device can only be configured on the Installer menu.
To start the installer menu, tap the MENU button for 10 seconds or more. The menus that can be configured will then
be available. There are two: the LINK menu and the SERVICE menu.
1. Switch on the device's power supply.
a. All the icons on the screen will be displayed for three seconds.
b. After three seconds, the device software version will be displayed on the bottom right-hand side corner of the screen.
c. The device automatically starts the RF link for communications with the unit.
2.
The icon starts to flash as it looks for the Ventilation Unit.
a. If the link is made correctly, the screen displays BND.
The device is ready to use.
a. If the link is not made correctly, the screen displays NO BND. Tap the OK button to start a new link.
1. Tap the MENU button repeatedly to run through the menus.
2. Tap the ACCEPT button when the service menu icon appears.
3. The 2 digit value display on the left shows an index number that flashes. The corresponding value and this setting's unit
are shown on the 4 digit value display on the right.
4. Tap the UP button or the DOWN button to run through the index numbers.
