Package
Overview
Installation
1
2
3
4
►
Connecting
Network
Cable
2
1
3
*
1 It
is
recommended
to
install
the
Security
cap
for
network
cable connection
.
*
2
If
the PoE network
switch
is
used
to
connect
the
camera
,
DC12V
power supply
is
not
required
.
①
Loosen
the
nut
from
the
main
element.
②
Run
the
network
cable (without
RJ 45
connector) through the
both elements. Then
crimp
the
cable
with
RJ 45
connector
.
③
Connect
the
cable
to
the
hermetic
connector
.
Then
tighten
the
nut
and
the
main
cover
.
Thank you for purchasing Sibell. We are always looking to
improve and will update the products or procedures as technology
changes and the industry adapts. If you need further product
assistance please contact your technical support specialist.
Content is subject to change without notice.*.
Warning
and
Caution
■
If the product does not work properly, please contact your dealer
or the nearest service center. Never attempt to disassemble the
camera yourself. (We will not be responsible for any problems
caused by unauthorized repair or maintenance.)
■
Keep away from liquid while in use, due to risks of electric shock
■
When using this product, you must be in compliance with the
electrical safety regulations of the region. When the product is mounted
on wall or ceiling, the device should be secured firmly.
■
Do not use camera beyond specified voltage range
.
■
Do not drop the camera or subject it to physical shock.
■
Avoid touching the camera lens.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
If the device will not be used for a long time, please cover the lens
cap to protect the device from dirt.
■
Do not aim the camera at the sun or extra bright places.
■
Do not place the camera in extreme hot or cold temps (the operating
temperature shall be -20˚C~50˚C), dusty or damp locations, and do
not expose it to high electromagnetism radiation.
■
To avoid heat accumulation, good ventilation is required for
operating environment.
■
Regular Maintenance is recommended for all devices
Quick
Start
Guide
Network
Camera
Camera
Quick
start
guide
CD
Security
cap
Plastic
plug
×3
Drill
template
Rubber plug
Screwdriver
3 tapping screws PA 4×25
Please make sure that the wall or ceiling is strong enough to
withstand 3 times the weight of the camera. Please install and use the
camera in a dry environment. Advised: If lens cover is removed, re-
apply the cover within 4 hours.
①
Drill the screw holes and the cable hole on the wall according to
the drill template.
Foc
us
Zo
om
Focus
Zoom
∅
130.7
∅
119.5
∅
4.5
120°
120°
103.5 mm
59.7mm
29.9mm
Network Cable
Zoom
Focus
1
2
3
4
②
Route the cables and connect the power cable and network cable.
And then secure the camera to the ceiling or wall with the screws.
Power
Cable
3
4
Fo
cu
s
Zo
om
1
2
DC12V
Network
Cable
Foc
us
Zo
om
To Use
Security
Cap: you must have experience in cable termination
