3
EN - ROTATING BARBER POLE LIGHT
This appliance is intended for use in a hair/barbering salon.The barber pole can be installed outdoor but its plug and power switch need to be installed indoor.
GENERAL USER INFORMATION – WARNINGS AND DISCLAIMERS
• This is a device for professional use only.
• Before using the appliance for the first time, you must read and understand the operation manual completely.
• Consider the operation manual as part of the product and store it in a safe and accessible place. Include this operation manual if passing the appliance on to a
third party.
• The manufacturer can in no case be liable for any damage caused by misuse, neglect, use for non-intended purpose, failure to install correctly, failure to follow
any manufacturers guidelines/instructions for use and general care, normal wear and tear, repairs and/or modifications made by unauthorized third parties or use
of non-approved spare parts or accessories.
• In the case of conflicts with national safety specifications or instructions, the national requirements must be followed.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
User instructions
A.
1. ABS top dome
2. LED power supply
3. Painted iron mounting plate
4. ABS inner cylinder mounting wheel
5. ABS main body
6. Hollow steel bolt
7. ABS lamp sleeve
8. Stainless steel wall mount
9. LED tube
10. PET inner rotating cylinder
11. Acrylic outer cylinder
12. ABS lamp sleeve
13. ABS main body
14. ABS inner cylinder mounting wheel
15. Motion transferring metal arm
16. ABS motor bushing
17. Painted iron motor mounting plate
18. Synchronous permanent magnet motor
19. ABS bottom bowl
20. Power cord
21. On/off switch
Using the product:
1. Connect the product to the correct power supply.
2. Use the On/off switches on the power cord to light the lamp and
start rotation. One switch controls the light and another controls the
rotating cylinder.
3. Use the switches to turn off the lamp/cylinder and remember to
unplug product after use.
4. In cold weather, the lamp may initially appear less bright than usual, however will gradually increase in brightness. This is normal.
B. INSTALLING THE PRODUCT:
5. Upon installing and mounting the barber pole, please first ensure the product is in full working order.
6. You will need an electric drill to drill holes for the plastic anchors. An 8mm diameter drill is recommended.
7. First, mount the upper bracket and ensure it is perpendicular to the plane.
8. Then measure out the distance between the two holes on the wall mount.
9. After having mounted the two brackets, simply screw the pole onto the brackets.
C. CIRCUIT DIAGRAM
1
2
5
6
7
9
10
11
12
13
14
15
17
19
18
16
21
20
8
4
3
Ballast
Lamp
Motor
Switch 2
Switch 1
L
N
A
C
B
d
2.8 inch / 7 cm
1
2
5
6
7
9
10
11
12
13
14
15
17
19
18
16
21
20
8
4
3
Ballast
Lamp
Motor
Switch 2
Switch 1
L
N
A
C
B
d
2.8 inch / 7 cm
