e015x DA15Kx
User guide (v.02)
pag.3
Printed in
e015-di DA15K [Eng].docx
Siap+Micros S.r.l.
1.3 Moving
In order to avoid any damage to the device during transportation, please keep it in upright position without
shaking.
1.4 Unpacking
Before unpacking and installing the device, please make sure you have taken the following precautions:
-
Use proper gloves in order to be protected against possible abrasions etc.
-
If you find any damage caused during transport due to the supplier, return the instrument to the supplier.
-
Once unpacked, place the DA15K and the parts that make it up on a flat surface.
-
Always avoid flip the data logger to protect the display.
-
Pay attention to the socket in the front and on the sides of the case of the equipment during operation.
Before installing the device, please check that:
-
The network voltage in the installation area complies with the operating conditions of the instrument.
-
Check that the main switch on the instrument is turned off.
Avoid turning the power on until you have carefully followed the instructions of installation and start-up in this
manual.
1.5 Safety procedure to turn on DA15K data logger
A safety procedure must be followed when turning on a DA15K with an external power supply and a 12V
backup battery.
1. Connect the battery in the power supply connector at pins BATT
– GND (see chapter 1.9 Description
of case and connections).
2. Take care of the polarity of the battery connections: BATT is the positive terminal and GND is the
negative.
3. Connect the external 12V DC power supply in the power supply connector at pins VCC
– GND (see
chapter 1.9 Description of case and connections). Take care that the power supply is turned off.
4. Take care of the polarity of the power supply connections: VCC is the positive terminal and GND is
the negative.
5. Turn on the DA15K in battery mode with the external power supply switched off.
6. Turn on the external power supply.
1.6 During operation
During operation, please avoid to alter the electrical connections related to analog and digital inputs; also avoid
to alter the connections of the power supplies.
