4
NETWORKS
AP25
2. Installing AP25
STEP 1
Connect one end of an RJ45 Ethernet cable to the LAN OUT port of the adapter
and the other end to the LAN of AP25.
i
Note
: You need one Category 6 (Cat 6) Ethernet cable with RJ-45 connector. Maximum
length of the RJ45 Category 6 cable is 100 meters for up to 200mW radio. For
high power radio frequency, use a high rating PoE adapter.
STEP 2
Connect the RJ45 Ethernet cable attached to the PoE adapter to a network device,
such as a switch or to the system that you use to configure AP25.
i
Note
: PoE power input: Passive PoE (Preferred 48V DC).
STEP 3
Connect the PoE adapter to the main electrical supply and the power cord
plugged into the socket of the adapter. Now, turn on the power supply.
AP25 starts receiving power through the PoE adapter.
STEP 4
Verify the availability of power to AP25 by checking the power LED. Green
color indicates input power is being supplied to the AP25. In case AP25 is not
powered-up, please refer “
Quick Troubleshooting
”section.
Congratulations! The installation of AP25 is complete.
PoE Adapter
Pole
Switch
AP25
Internet