173
PREPARING THE REMOTE CONTROL
Please follow the steps below to make it operate correctly:
33. To operate the appliance via remote control, please remove the plastic protection from
the battery compartment.
34. To change the battery, carry out the following steps:
Pull out the battery holder on the back of the remote control, remove the old battery and
then insert a new one:
35. Please always pay attention to the polarity markings
(+/-) on the battery and the battery holder:
36. Then insert the battery holder back into the remote control.
Starting heating and stopping standby mode
-
Press the power button
on the heater to switch it on or press it again to return to
standby mode (switch off).
-
The
symbol will show on the display to indicate the heater is active
-
The current temperature will also be shown on the LED display.
Setting the temperature
-
The temperature range is 5°C to 50°C, and the default temperature is 15°C.
-
If the room temperature is 1°C higher than the temperature setting, the heater will
switch off. If the room temperature is 2°C lower than the temperature setting, the heater
will switch on again.
-
Press
or
to set the temperature in increments of 1°C.
-
will flash on the display after each setting.
-
The temperature will be saved after 3 seconds of inactivity.
