- 63 -
HDD Power Down
The IDE hard drive will spin down if it is not accessed within a specified
length of time. Options are from 1 Min to 15 Min and Disabled.
Ø
The choice: Disabled or 1 Min~15 Min.
Suspend Mode
When this item is not disabled and after the setup time of system inactiv-
ity, all devices except the CPU will be shut off.
Ø
The choice: Disabled, 1 Min, 2 Min, 4 Min, 6 Min, 8 Min, 10 Min,
20 Min, 30 Min, 40 Min, or 1 Hour.
Video Off Option
This item specifies on/off for the monitor when it enters the power-
saving mode.
Ø
The choice: Always On or Suspend ->Off.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
Blank Screen
The item only writes blanks to the video buffer.
DPMS Support
Initial display power management signaling.
Ø
The choice: V/H SYNC+Blank, Blank Screen, or DPMS Support.
MODEM Use IRQ
This determines the IRQ which the MODEM can use.
Ø
The choice: 3, 4, 5, 7, 9, 10, 11, or NA.
Soft-Off by PWRBTN
Under ACPI you can create a software power down. In a software
power down, the system can be resumed by Wake UP Alarms. This
item lets you install a software power down that is controlled by the
power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay
4 Sec, then you have to hold the power button down for 4 seconds to
cause a software power down.
Ø
The choice: Delay 4 Sec or Instant-Off.
Run VGABIOS if S3 Resume
This item defines if the VGA BIOS runs when the system wakes up from
S3.
Ø
The choice: Auto, Yes or No.
Power fail resume
The system power status after the resume of power fail.
Ø
The choice: OFF or ON.
