Shure Incorporated
3/3
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
6.
7.
Using a small Phillips-head screwdriver, unscrew the terminal end of the GREEN lead wire from the back of
the inside of the case.
Remove the old cartridge and attached leads from the case, pulling the BLUE, RED, and GREEN lead wires
with it.
Remove the extension spring.
Remove the GREEN lead wire from the RED and BLUE wires and discard the old cartridge. Be sure to save
the GREEN lead wire.
Installing the New Cartridge
Hold the stripped end of the GREEN lead wire (not the termimal end) next to the stripped ends of the BLUE
and RED lead wires of the replacement cartridge and twist them together for about one (1) inch.
Thread the twisted ends through the larger end of the extension spring.
Push the twisted ends through the hole in the bottom of the the case so the edge of the extension spring fits
just inside the hole and the wire leads appear on the outside.
Untwist the BLUE, RED, and GREEN lead wires.
Pull the GREEN wire all the way through. The terminal end should pull the extension spring through in front of
it. The extension spring should now be sticking out of the case.
Using a Phillips head screwdriver, secure the terminal end of the GREEN lead wire to the screw hole in the
back of the inside of the case.
Place the new cartridge inside the case with the yellow tape strip facing up, aligned with the logo on top of the
case. Make sure the wires rest in the intended groove so they are not pinched between the cartridge and
case.
Reattach the screen and grille assembly.
Replacing the Stand Adapter
Insert the BLUE, RED, and GREEN lead wires through the hole on the front of the stand adapter and out
through the XLR connector chamber.
Insert the extension spring into the opening of the through-hole. Make sure the spring is pushed in until it
bottoms out.
Using a 1/16” Allen wrench, secure the setscrew on the stand adapter to lock the extension spring in place.
Place the compression spring and metal washer over the threaded end of the knob screw. Place the rubber
washer between the stand adapter and the inside of the flange. Make sure the rubber washer is on the
groove side of the stand adapter. Secure the stand adapter to the case with the knob screw.
Solder the BLUE, RED, and GREEN lead wires to pins 2, 3, and 1 respectively.
Insert the XLR connector in the XLR connector chamber so the notch on the connector fits into the groove
inside the chamber. Be careful not to pinch the lead wires.
Using a small flathead screwdriver, turn the XLR setscrew clockwise to secure the connector to the stand
adapter.
Alternative Installation Procedure
As a time-saving alternative, it is also possible to install the cartridge by carefully splicing and soldering the three
leads between the cartridge and the case. If this option is chosen, be sure to trim unnecessary lead lengths and
wrap the soldered connections carefully with tape to prevent shorts.
