TRANSMITTER CONTROLS AND CONNECTORS
Quick Start
Step 1: Power and Antenna Connection
Connect an antenna to each of the antenna connectors.
Connect the power supply to the receiver and plug into an AC
power source.
Connect the receiver audio output to a mixer or amplifier.
Step 2: Scanning for the Best Available Frequency
1. Press the menu button on the receiver to access the scan function.
Press and hold the power button to turn on the receiver.
2. Press the enter button to start a frequency scan. The scan icon will flash
while in scan mode. When the scan is complete, the selected group and
channel appears on the display.
IN ST R U ME NT OU T
Step 3: Install Batteries into Transmitter
AA Batteries
Shure SB900 Battery
Press the side tabs on the bodypack or unscrew
the cover on the handheld as shown to access the
battery compartment.
• AA Batteries: Place batteries (note polarity markings) and AA Adaptor as shown
• Shure SB900 Battery: Place battery as shown (note polarity markings), remove AA
Adaptor from bodypack transmitter, stow AA Adaptor in door for handheld transmitter
Step 4: IR Sync to Create an Audio C hannel
1. Press the sync button on the receiver.
The red ir LED will blink indicating that
sync mode is active.
2. Align the IR sync windows of the
3. sync good appears on the display when IR sync is complete. The
blue rf LED will illuminate indicating that the transmitter is within
range of the receiver.
transmitter and receiver at a distance
of <15 cm (6 in.). When the transmitter
and receiver are aligned, the red ir
LED remains on and the sync will
automatically occur.
Note: If the IR sync fails, repeat the IR sync procedure, carefully maintaining
alignment between the IR windows of the transmitter and receiver.
Step 5: Sound Check and Gain Adjustment
1. Test the transmitter at performance levels while monitoring the audio meter and the audio LED.
Tip: The audio meter should display at least 3 bars and the audio LED should be green. Reduce the gain if there is
audible distortion of the audio.
2. Increase or decrease the gain if necessary by pressing the
buttons on the receiver front panel.
