Input Port Isolation
50 dB, typical
RF Input Power
Operating Range, Per Channel
4.5 to 15 dBm
LED Indicator Minimum Detection Threshold
3 dBm±1.5 dB
RF Overload LED Threshold
17.5 dBm±1 dB
Impedance
50 Ω
RF Output
RF Frequency Range
470 to 865 MHz
Output Intercept Point (OIP3)
48 dBm, typical
Connector Type
BNC
Impedance
50 Ω
Reverse Isolation
Ouput to Input
40 dB, typical
Gain
Input to any output port
−5 to 0 dB
LICENSING INFORMATION
Licensing: A ministerial license to operate this equipment may be required
in certain areas. Consult your national authority for possible requirements.
Changes or modifications not expressly approved by Shure Incorporated
could void your authority to operate the equipment. Licensing of Shure wire-
less microphone equipment is the user’s responsibility, and licensability de-
pends on the user’s classification and application, and on the selected fre-
quency. Shure strongly urges the user to contact the appropriate telecommu-
nications authority concerning proper licensing, and before choosing and
ordering frequencies.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation of this device is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any inter-
ference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Federal Communications Commission RF Exposure Notice:
Antennas used for the purpose of radiating signals are limited to a maximum
gain of 14 dBi. Each antenna must be positioned to observe minimum sepa-
ration requirements from all users and bystanders. The following guidelines
should be used when considering separation distances.
Antennas must be placed such that, under normal conditions, personnel
cannot come within 72 cm (~2.5 ft.) from any antenna. Adhering to this mini-
mum separation will ensure that the employee or bystander cannot exceed
RF exposures beyond the maximum permissible limit as defined by 47 CFR
1.1310, i.e., limits for General Population/Uncontrolled Exposure.
Certifications
Meets essential requirements of the following European Directives:
•
Low Voltage Directive 2006/95/EC
Conforms to the relevant requirements of regulation (EC) No.278/2009, for
low voltage external power supplies.
•
R&TTE Directive 99/5/EC
•
Conforms to European Regulation (EC) No. 1275/2008, as amended.
•
WEEE Directive 2002/96/EC, as amended by 2008/34/EC
•
RoHS Directive 2011/65/EU
Note:
Please follow your regional recycling scheme for batteries and
electronic waste
Meets requirements of the following standards:
Certified under FCC Part 74.
Certified by IC in Canada under RSS-123 and RSS-102.
FCC ID:
DD4PA411A.
IC:
616A-PA411A.
The CE Declaration of Conformity can be obtained from Shure Incorporated
or any of its European representatives. For contact information please visit
www.shure.com
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: [email protected]
Shure Incorporated
PA411
Antenna Combiner
4/4
Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone: +1-847-600-2000 Email: [email protected]
