Shure Incorporated
6/15
⑩
Factory Service Window
Used for importing firmware onto the bodypack at the factory (not user-serviceable)
⑪
Battery Compartment
Uses a Shure SB900A rechargeable battery or two AA batteries
⑫
Removable AA Adapter
Remove to use with a Shure SB900A rechargeable battery
Note:
To remove, open the door and slide the adapter out. To reinstall, press the adapter into place—there is an au
dible click when seated.
Setup
①
Insert batteries
Use the Shure SB900A rechargeable battery pack or two AA batteries.
②
Connect the bodypack
to an audio source using
the supplied Ysplitter ca
ble
Connect the 5-pin LEMO connector to the bodypack, with the red dot on the cable aligned
with the notch inside the bodypack connector. Route the two XLR connectors on the cable to
the appropriate mixer outputs. See the system overview diagram for a signal routing exam
ple.
Note: the bodypack can connect either directly to the mixer or through a patch bay on stage.
③
Put on the earphones
and connect them to the
headphone output
The P9HW is designed to perform best with Shure earphones, but works with any head
phones or in-ear monitors that have a standard 1/8-inch (3.5 mm) stereo plug.
④
Turn the power on
Turn the volume knob clockwise until it clicks to turn on the power.
Caution: do not turn the volume knob all the way up when turning the power on.
⑤
Slowly increase the vol
ume until it reaches a com
fortable level for listening
To set a maximum volume limit, use the VLIMIT function. See the utilities section of this
guide for more information.
