Shure Incorporated
46/59
•
1.
2.
3.
4.
•
•
•
AES67 cannot operate when the transmit and receive devices both support Dante.
Shure Device Supports:
Device 2 Supports:
AES67 Compatibility
Dante and AES67
Dante and AES67
No. Must use Dante.
Dante and AES67
AES67 without Dante. Any other au
dio networking protocol is acceptable.
Yes
Separate Dante and AES67 flows can operate simultaneously. The total number of flows is determined by the maximum flow
limit of the device.
Sending Audio from a Shure Device
All AES67 configuration is managed in Dante Controller software. For more information, refer to the Dante Controller user
guide.
Open the Shure transmitting device in Dante Controller.
Enable AES67.
Reboot the Shure device.
Create AES67 flows according to the instructions in the
.
Receiving Audio from a Device Using a Different Audio Network Protocol
Third-party devices:
When the hardware supports SAP, flows are identified in the routing software that the device uses. Oth
erwise, to receive an AES67 flow, the AES67 session ID and IP address are required.
Shure devices:
The transmitting device must support SAP. In Dante Controller, a transmit device (appears as an IP address)
can be routed like any other Dante device.
Networking and Dante
Digital Audio Networking
Dante digital audio is carried over standard Ethernet and operates using standard internet protocols. Dante provides low laten
cy, tight clock synchronization, and high QualityofService (QoS) to provide reliable audio transport to a variety of Dante de
vices. Dante audio can coexist safely on the same network as IT and control data, or can be configured to use a dedicated net
work.
Compatibility with Dante Domain Manager
This device is compatible with Dante Domain Manager software (DDM). DDM is network management software with user au
thentication, role-based security, and auditing features for Dante networks and Dante-enabled products.
Considerations for Shure devices controlled by DDM:
When you add Shure devices to a Dante domain, set the local controller access to
Read Write
. Otherwise, you won't be
able to access to Dante settings, perform a factory reset, or update device firmware.
If the device and DDM can't communicate over the network for any reason, you won't be able to control Dante settings,
perform a factory reset, or update device firmware. When the connection is reestablished, the device follows the policy set
for it in the Dante domain.
If Dante device lock is on, DDM is offline, or the configuration of the device is set to Prevent, some device settings are dis
abled. These include: Dante encryption, MXW association, AD4 Dante browse and Dante cue, and SCM820 linking.
See
Summary of Contents for Microflex Advance MXA910
Page 28: ...Shure Incorporated 28 59...
