Shure Incorporated
6/12
External Power Supply (Optional)
If Power over Ethernet (PoE) is not available, power the access point using an external power source supplying 15
V DC ±10% (600 mA).
1. Connect the power source to the external power supply jack.
2. Tighten the locking ring to secure the plug.
3. Plug the power supply AC line cord into an AC power source.
4. Connect a CAT 5 Ethernet cable to the access point to provide a network connection.
Networking
Networking the access point using a Shure AXT620 Ethernet switch or a DHCP-enabled router automatically as-
signs an IP address, simplifying network setup. The network connection allows the access point to share data with
networked components and enables wireless control of the transmitters. To manually assign an IP address to the
access point, use Wireless Workbench 6.
Reset Option
Pressing the reset button located on the bottom of the housing restores the access point to the following settings:
•
IP Address Mode = DHCP
•
Channel Agility = Enabled
•
Device ID = AXT610
•
Device Association Tables will be cleared
Positioning the Access Point
• Provide a clear line of sight between the access point and transmitters: mount the access point on a micro-
phone stand or wall to elevate above obstructions
•
Position the antenna vertically for optimal performance. The swivel joint on the antenna allows a wide range of
positioning to maintain a vertical alignment