Shure Incorporated
9/22
1.
2.
1.
2.
◦
◦
1.
2.
•
Note:
For smaller systems, connect the Spectrum Manager and receivers using the Ethernet ports on the back panel. The devices fall back to compatible ad
dresses if the IP Mode is set to Automatic and there is no DHCP server.
Automatic IP Addressing
If using a Shure AXT620 Ethernet switch, set the
DHCP
switch to
ON
.
Set the IP mode to automatic for all devices (
Util
>
Network
>
Mode
>
Automatic
)
Manual IP Addressing
Connect the Spectrum Manager and receivers to an Ethernet switch.
Set the IP Mode to
Manual
for all devices:
Menu:
Util
>
Network
Use the control wheel to set valid IP addresses for all devices. Set the subnet mask for all devices to the same val
ue.
Device Reset
Reset your device to restore factory settings.
Go to
Util
>
More
>
Reset
All
.
Press
enter
to reset the device.
Troubleshooting
Use only one DHCP server per network
All devices must share the same subnet mask
All devices must have the same level of firmware revision installed
Look for the network icons on the display of each device:
If the icon is not there, check the cable connection and the LEDs on the network jack.