8
ADX1M Transmitter Overview
⑥ Enter Button (O)
Selects menu screens for editing and
confirms parameter changes.
⑦ Display
View menu screens and settings.
Press any button to activate the
backlight.
⑧ Power LED
- Green = unit is powered on
- Red = low battery, Mute Mode enabled,
input overload, or battery error (see
Troubleshooting)
⑨ Battery Latch
Latch to secure the battery.
⑩ Battery
Shure rechargeable battery.
① Input Jack
Connects to a 3-Pin LEMO connector
microphone or instrument cable.
② Up Button (⋀)
Use to navigate through parameter
menus and to change settings.
③ Infrared (IR) Port
Align with the receiver IR port during
an IR Sync for automated transmitter
tuning and setup.
④ Power and Exit Button (X)
Press and hold to turn transmitter
on or off. Acts as a 'back' button
to return to previous menus or
parameters without confirming a
value change.
⑤ Down Button (⋁)
Use to navigate through parameter
menus and to change settings.
1
2 3 4
5
6
9
8
10
7
ADX1M
Top
Bottom
Front
Rear
Home Screen Display
The home screen shows transmitter information and status.
Tip: There are four options to choose the information shown on the home
screen. Use the arrow buttons to select one of the following choices:
• Name
• Frequency Setting
• Group (G) and Channel (C)
• Device ID
Shure
470.200
MHz
7:45
The following icons appear to indicate transmitter settings:
Battery runtime in hours and minutes or bar display
Key: Displayed when encryption is enabled
Lock: Displayed when controls are locked. Icon will flash if
access is attempted to a locked control (power or menu).
ShowLink signal strength displays 0 to 5 bars
STD: Standard Transmission Mode
HD: High Density Transmission Mode
Box: When the box has an "x", Mute Mode is on and
engaged. If the box is empty, Mute Mode is on, but not
engaged.
Transmitter Controls
Use the controls to navigate through parameter menus and change
values.
ADX1M
^
X
^
O
∨∧
Use to scroll through menu screens and to change param-
eter values.
X
Acts as a back button to return to previous menus or pa-
rameters without confirming a value change.
O
Enters menu screens and applies parameter changes.
Tip: Use the following control shortcuts for quick set up:
•
Hold the ∧ and
X
buttons while powering on to lock the transmitter
• Hold the
O
and
X
buttons while powering on to set the transmitter RF
output to mute
Locking the Interface
Lock transmitter interface controls to prevent accidental or unauthorized changes to parameters. The lock icon appears on the home screen when the
interface lock is enabled.
1. From the
Utilities
menu, navigate to
Lock
and select one of the following lock options:
-
None:
The controls are unlocked
-
Power:
The power switch is locked
-
Menu:
The menu parameters are locked
-
All:
The power switch and menu parameters are locked
2. Press
O
to save.
Tip: To quickly unlock a transmitter: Press
O
twice, select
None
, and press
O
.
