Operating Instructions
5
Output1
HDTV
HDTV
HDTV
HDMI cable
Cat5e cable
IR cable
Receiver
Receiver
Receiver
Receiver
IR-RX
IR-RX
HDMI cable
Ethernet cable
Smart TV
Router
Internet
RS232 cable
RS-232 pin assignment
HDBaseT Splitter
PIN
Assignment
1
NC
2
TX
3
RX
4
NC
5
GND
6
NC
7
NC
8
NC
9
NC
7)
To get on the ethernet,pls connect as below steps:
1.Connect ethernet cable into ethernet port on HDBaseT spl
itter.
2.Connect ethernet cable with
TV and ethernet extender receiver
Note:1.The ethernet function is designed for ethernet compatible receiver units only
.
2.Only output1 with ethernet function.
8) Copy EDID function
Copy the EDID of the sink which connected the OUTPUT3,it is suggested to put lowest or
For example:
One SDTV(480p) ,one HDTV(1080p)
,
in order to make the 4
TV work
,
you need to put the
SDTV is connected to the output 3
.
Computer RS232 port
PIN
Assignment
1
NC
2
RX
3
TX
4
NC
5
GND
6
NC
7
NC
8
NC
9
NC
Front Panel
Rear Panel
Power ON/OFF
Status indicator lamp:The LED will illuminate when the HDMI equipment is connected.
Power indicator lamp:The LED will illuminate when the power is
on.
Reset key
Power input port
1
3
2
4
RS232 port
Output2,3&4 port ( IR pass-though)
1
2
2
3
4
5
4
4
6
3
4
5
6
HDMI input port
Connecting and operating
1) Connect the HDMI input sources into HDBaseT splitte
r.
2) Connect HDMI receiver over Cat5e/Cat6 cables to both the Cat5e/6 port of HDBaseT Splitter
and Cat5e/6 port of Receive
r
,The RJ45 connections must follow EIA-TIA 568b standards.
3) Connect the HDMI output from the Receiver(RX) into the display HDMI input.
emitter onto the source IR windows
. .
5) Connect IR-RX cable into IR-RX port on the receiver and af
x the receiver on the display frame
/bezel or the display stand.
Note
：
Do not a x the emitter until the placement is tested.
6) Power up all units
,
the splitte
r
,Receiver
,
sources and displays.
Output1 port ( Ethernet,RS232&IR pass-though)
Ethernet port
