18
ENG
S.H.S. s.r.l. Via F.lli Rosselli, 29 20027 Rescaldina (MI) – ITALY
Tel. +39 0331 466918 Fax. +39 0331 466147 www.shsitalia.it
SHS automation products must be handled, installed and maintained by competent personnel only and
Instructed on the installation of automation components, and only for the purposes described in the user
manual. Installers must pay particular attention to the potential risks caused by mechanical and electrical hazards.
It is very important that applications and installations meet all applicable safety requirements.
Each installer is obliged to take responsibility for verifying their knowledge and understanding of everyone the applicable
safety standards.
Any use that does not meet the safety requirements can damage the equipment and injure the user.
SHS s.r.l. will not be held responsible, and will not take any responsibility for damage caused by products
handled and / or improperly installed, or in cases where the customer has permitted, or performed, modifications
and / or repairs not authorized by SHS s.r.l.
SHS drives are high-performance automation devices capable of generating rapid movements high forces.
Pay close attention, especially in the installation and application development phases.
Use only properly sized equipment for the application.
SHS devices are considered automation components and are sold as finished products to be installed only by qualified
personnel and in accordance with all local safety regulations.
Specialists must be able to recognize the possible dangers that may arise from programming, from the modification of the
parameter values and, in general, from mechanical, electrical and electronic equipment.
SHS s.r.l recommends always following the safety regulations. Failure to comply with these rules could cause damage to
people and / or things.
General precautions:
•
This manual is subject to change due to product improvements, changes in specifications or improvements of the
manual itself.
•
SHS s.r.l. is not responsible for damages to things and / or persons caused by incorrect installations and / or
modifications not authorized by the product.
Damaged control systems must not be mounted or put into operation to avoid injury people and damage to things.
Any modification or variation made to the drive systems is forbidden e involves the termination of any right to
warranty interventions or any liability obligation.
Security notes
