10
Ordercode: 40429
Star Dream 6x3m 128 LED RGB
Controller
Fig. 02
01)
LCD d control buttons
02)
Curtain connectors OUT
03)
3-pin DMX signal connector IN
04)
3-pin DMX signal connector OUT
05)
Built-in microphone
06)
100–240 V pro power connector IN
07)
Ground/earth connection
Installation
Remove all packing materials from the Star Dream 6x3m 128 LED RGB. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 110V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
