8
Ordercode: 41267
Pixel Square 16 COB
Backside
04)
Safety eye
05)
3-pin DMX signal connector OUT
06)
3-pin DMX signal connector IN
07)
Ground/earth connection
08)
IEC power connector 100-240V IN + Fuse F1,5A/250V
09)
IEC power connector 100-240V OUT
10)
LCD d menu buttons
Installation
Remove all packing materials from the Pixel Square 16 COB . Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Fig. 02
