SHOWTEC Phantom 70 Beam RGBW, Manual

Page: 11 / 36

10
Ordercode: 40051
Phantom 70 Beam RGBW
Backside
Fig. 03
05)
Fuse T3A/250V
06) 3-pin DMX signal connector IN
07) 3-pin DMX signal connector OUT
08) Blue Pro Power connector IN
09) Grey Pro Power connector OUT
10) Power switch ON/OFF
11) Ground/earth connection
Installation
Remove all packing materials from the Phantom 70 Beam RGBW. Check if all foam and plastic padding
is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.