SHOWTEC Performer 2000 Fresnel DDT MKII V2, Manual

Page: 14 / 32

13
Ordercode: 33037
Performer 2000 Fresnel DDT MKII
Control Modes
There are 3 modes: • Stand-alone
• Master/Slave
• DMX-512 (1CH, 2CH, 5CH)
One Performer (Stand-alone)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Performer is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 18-22 for more information.
Multiple Performers (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin/5-pin XLR cable to connect the Performer.
The pins: 01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in fig. 06. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 18-22. This means that
you can set your desired operation mode on the master device and all slave devices will react the
same as the master device.
Multiple Performers (Master/Slave control)
Fig. 06