SHOWTEC Maniac FX 7, Manual

Page: 15 / 28

14
Order code: 41307
Maniac FX 7
Main Menu Options
Upon start-up the display will show the current version of the firmware . After 2 seconds the display
will show the current operation mode or the current DMX address, if the device is connected to a DMX
controller:
.
●
Use the MODE button to navigate through the Main Menu, to exit the current menu and/or to return
to the Main Menu.
● Use the UP/DOWN buttons to navigate through the submenus or to increase/decrease numeric
values.
● Use the ENTER button to open the desired menu or to set the currently selected value.
The Main Menu has the following options:
Auto mode
Sound-controlled mode
Manual settings
DMX settings
Slave mode settings
System settings
1. Auto Mode
In this menu you can start one of the built-in programs.
01)
Press the MODE button to navigate through the Main Menu until the display shows .
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to select one of the 4 types of built-in programs:
Auto program (Wash/Beam/Strobe)
Built-in mix programs (Wash/Beam)
Built-in Beam programs
Built-in Wash programs
04)
Press the ENTER button to confirm the selection and to open the submenu with the built-in programs.
Note: Pressing the ENTER button, after you have selected the , will activate the Auto program and
the display will show . To adjust the speed, see steps 6-7 below.
05) Press the UP/DOWN buttons to select one of the built-in programs:
16 built-in mix programs (Wash/Beam)
7 built-in Beam programs
10 built-in Wash programs
06)
Press the ENTER button to set the speed of the selected built-in program.
07) Press the UP/DOWN buttons to adjust the speed between , from slow to fast.
08) Press the ENTER button to confirm the speed setting and to activate the program.