SHOWTEC Hydrogen DMX MKII, Manual

Page: 4 / 24

Ordercode: 43151
Hydrogen DMX MKII
Before the initial start-up, please make sure that there is no damage caused by transportation. Should
there be any, consult your dealer and do not use the device.
To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to
follow the safety instructions and warning notes written in this manual.
Please consider that damages caused by manual modifications to the device are not subject to
warranty.
This device contains no user-serviceable parts. Refer servicing to qualified technicians only.
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
• Never let the power cord come into contact with other cables! Handle the power cord and all
connections with the mains with particular caution!
•
Never remove warning or informative labels from the unit.
• Do not open the device and do not modify the device.
•
Never use anything to cover the ground contact.
• Never leave the device running without a lamp!
•
Never look directly into the light source.
•
Never leave any cables lying around.
• Do not insert objects into air vents.
•
Do not connect this device to a dimmerpack.
• Do not switch the device on and off in short intervals, as this would reduce the device’s life.
•
Do not shake the device. Avoid brute force when installing or operating the device. The Hydrogen
DMX MKII reacts very sensitively to movement.
• Never use the device during thunderstorms, unplug the device immediately.
•
Only use device indoor, avoid contact with water or other liquids.
•
Do not touch the device’s housing bare-handed during its operation (housing becomes hot).
• Only operate the device after having familiarized with its functions.
•
Avoid flames and do not put close to flammable liquids or gases.
• Always keep case closed while operating.
•
Always allow free air space of at least 50 cm around the unit for ventilation.
•
Always disconnect power from the mains, when device is not used or before cleaning! Only handle
the power cord by the plug. Never pull out the plug by tugging the power cord.
•
Make sure that the device is not exposed to extreme heat, moisture or dust.
• Only install the device with the hanging bracket.
•
Make sure that the available voltage is not higher than stated on the rear panel.
•
Make sure that the power cord is never crimped or damaged. Check the device and the power-
cord from time to time.
•
If the external cable is damaged, it has to be replaced by a qualified technician.
•
If the lens or glass is obviously damaged, it has to be replaced. So that its functions are not impaired,
due to cracks or deep scratches.
•
If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
•
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
•
If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
•
For adult use only. Light effect must be installed out of the reach of children. Never leave the unit
running unattended.
• For replacement, use fuses of same type and rating only.
•
The user is responsible for correct positioning and operating of the Hydrogen DMX MKII. The
manufacturer will not accept liability for damages caused by the misuse or incorrect installation of
this device.
3