10
Ordercode: 51340
Galactic RGB 720
Backside
Fig. 02
04)
Cooling Fan
05)
Lock On/Off
06)
Zoom
07)
ILDA Input
08)
ILDA Through
09)
MENU
10)
Remote Control
11)
Built-in Microphone
12)
Slot for SD Card with Lasershows
13)
LCD Display
14)
3-pin DMX signal connector (OUT)
15)
Ground/Earth connection
16)
IEC Power connector 100-240VAC
17)
Fuse 1.6AL/250V
18)
Power switch ON/OFF
19)
3-pin DMX signal connector (IN)
NOTE: Knowledge of DMX is required to fully utilize this unit.
Installation
Remove all packing materials from the Galactic. Check that all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be music-controlled by its built-in
microphone.
