10
Ordercode: 51332
Galactic G300
Backside
Fig. 02
01)
SD Slot
02)
LED d control b LED indicators
03)
Music Sensitivity
04)
X-Size
05)
Y-size
06)
ILDA Through
07)
ILDA Input
08)
RGB + ILDA LED
09)
Safety Eye
10)
3-pin DMX signal connector OUT
11)
Cooling Fan
12)
3-pin DMX signal connector IN
13)
ON/OFF
14)
Fuse 1,6A
15)
IEC Powerconnector
16)
Ground/Earth connection
17)
Remote Interlock safety connection
18)
Lock On/Off
Red ILDA LED = connection
Green ILDA LED = disconnection
Installation
Remove all packing materials from the Galactic. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be sound-controlled as it is equipped
with a built-in microphone.
