SHOWTEC Explorer 250 Basic, User Manual

Page: 4 / 26

2
WARNING
FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY
BEFORE YOUR INITIAL START-UP!
SAFETY INSTRUCTIONS
Every person involved with the installation, operation and maintenance of this device has to:
-
be qualified
- follow the instructions of this manual
Before your initial start-up, please make sure that there is no damage caused by transportation. Should
there be any, consult your dealer and do not use the device.
To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to follow
the safety instructions and warning notes written in this manual.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
This device contains no user-serviceable parts. Refer servicing to qualified technicians only.
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
•
Never let the power-cord come into contact with other cables! Handle the power-cord and all
connections with the mains with particular caution!
•
Never remove warning or informative labels from the unit.
•
Never use anything to cover the ground contact.
•
Never run the device without lamp!
•
Never ignite the lamp if the objective-lens or any housing-cover is open, as discharge lamps may
expose and emit a high ultraviolet radiation, which may cause burns.
•
Never lift the fixture by holding it at the projector-head, as the mechanics may be damaged. Always
hold the fixture at the transport handles.
•
Never place any material over the lens.
•
Never look directly into the light source.
•
Never leave any cables lying around.
•
Never unscrew the screws of the rotating gobo, as the ball bearing will otherwise be opened.
•
Do not insert objects into air vents.
•
Do not connect this device to a dimmerpack.
•
Do not switch the device on and off in short intervals, as this would reduce the lamp’s life.
•
Do not touch the device’s housing bare-handed during its operation (housing becomes very hot).
Allow the fixture to cool for at least 5 minutes before handling.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Only use device indoor, avoid contact with water or other liquids.
CAUTION!
Keep this device away from rain and moisture!
Unplug mains lead before opening the housing!
CAUTION! Be careful with your operations.
With a dangerous voltage you can suffer
a dangerous electric shock when touching the wires!