12
Ordercode: 44057
EventSpot 1600 Q4 Set
Setup and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 110 V specification product on 240 V power, or vice versa.
Charging the Built-in Battery
01)
Press the power buttons (05) at the bottom of each EventSpot to off position.
02)
Place the EventSpots in the charging case, on the 6 charging spots. Make sure that the battery
charger sockets (08) on the EventSpots are placed correctly in the chargers (Fig. 06).
03)
Connect the included power cable to the pro power connector IN (14).
04)
Plug the other end of the power cable into a proper electric power supply.
05)
Charge the battery (6 hours).
06)
The battery status indicators (19) will light green while charging is in progress.
Fig. 06
Important!
●
Charge only with the charging case open. If it is closed, the safety switch (20) will deactivate the
charging case.
●
When charging, keep the device at least 1 meter from flames or any other heat source.
●
When charging, the device may heat up. This is normal and shouldn’t affect the device’s lifespan or
performance.
●
Avoid depleting the battery below 10 %.
●
Do not charge for more than 24 hours.
●
Recharge within 3 days of use.
●
Press the power button (05) at the bottom of each EventSpot to off position, when storing for more
than 7 days.
●
Store in an upright position.
