11
Control Panel
When the indicator light is on, means the Dreamer is working
Fig. 6
A.
LED
D.
[MODE] Button
B.
Display
E.
Up Button
C.
[ENTER] Button
F.
Down Button
Control Mode
The fixtures are individually addressed
on a data-link and connected to the
controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address
and save it, the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Dreamer will respond to the controller.
Please note when you use the controller, the unit has
5
channels.
When using multiple Dreamer’s, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Dreamer should be
1(A001)
; the DMX address of the second
Dreamer
should be
1+5=6(A006
); the DMX address of the third Dreamer should be
6+5=11(A011)
, etc.
Please, be sure that you don’t have any overlapping channels in order to control each Dreamer
correctly.
If two or more Dreamer’s are addressed similarly, they will work similarly.
For address settings, please refer to the instructions under ”Addressing’ (menu
)
Controlling:
After having addressed all Dreamer fixtures, you may now start operating these via your lighting
controller.
Note:
After switching on, the Dreamer will automatically detect whether DMX 512 data is received or not.
If there is
no data received at the DMX-input, the “
LED
“ on the control panel will not flash.
The problem may be:
- The XLR cable from the controller is not connected with the input of the Dreamer.
- The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note:
It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Summary of Contents for Dreamer 31150
Page 1: ...Dreamer ORDERCODE 31150...
Page 21: ......
