7
Ordercode: 604083
Mirrorball Motor up to 30 cm
Installation
Remove all packing materials from the Mirrorball Motor up to 30 cm. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Installing the Mirrorball Motor
●
Install the mirror ball chain with the screw-on chain link at the installation eyelet of the mirror ball and
tighten the fixation screw.
●
Insert the fourth chain link of the mirror ball chain with the mirror ball in the screw-on chain link and
tighten the fixation screw.
●
Always install a safety chain that can hold at least 12 times the weight of the installation. The safety
chain must be slightly longer than the mirror ball chain, so that the safety chain will remain tension-
free. Pull the safety chain through the safety eyelet of the mirror ball and through the safety eyelet of
the motor.
●
Make sure that the chain’s length is not longer than 100 cm.
●
Make sure that the maximum drop distance never exceeds 20 cm.
●
Replace a safety chain which already held the strain of a crash or which is defective.
●
Never hang a mirror ball or other load at the safety eyelet. Loads must only be hanged at the quick
link of the installation eyelet, at the motor axle. If, for any reason, a mirror ball hangs at the safety
eyelet, immediately take the motor out of operation and uninstall the mirror ball. Have an expert
check the whole installation for defects.
●
Make sure that the rotation of the mirror ball is never obstructed by decoration material etc.
●
Make sure that the mirror ball cannot be affected by air streams. The mirror ball and the motor must
be installed and operated absolutely swivel-free.
●
Please check for safety in regular intervals. If the installation material (e. g. key ring, shackles or
screw-on chain links) or chain links have been deformed, uninstall the mirror ball immediately.
The fixation holes are located on the baseplate.
01)
Hold the baseplate onto the location where the device is to be installed.
02)
Mark the holes with a pen or a suitable tool.
03)
Drill the holes.
04)
Hold the baseplate in the desired position and tighten the screws.
Summary of Contents for 604083
Page 11: ...10 Ordercode 604083 Mirrorball Motor up to 30 cm...
Page 12: ...2021 Showtec...
