24
ColorCue 4
Product code: 50706
Programming Mode
In this mode you can program and edit scenes and chases. The scenes and chases can be assigned to
the 48 PLAYBACKS buttons (A)–(B).
The programming mode screen provides information about the selected PLAYBACKS button number, the
step number, the direction of the chase, the playback speed of the chase in bpm (beats per minute)
and the fade percentage. The programming screen appears after you press the RECORD button (60) in
step 2 in 6.7.1. Record a Scene (see pages 24–25) and 6.7.2. Record a Chase (see page 25).
●
Press and hold down the MODE button (56) for 3 seconds to enter programming mode. The LED on
the button will light up in blue.
●
Press and hold down the MODE button (56) again for 3 seconds to exit programming mode. The LED
on the button will light up in red and the device will return to manual mode.
Note:
Before exiting programming mode, make sure that you clear the programmer. See 6.5.6. Clear the
Programmer on page 20 for more information.
Record a Scene
Fig. 19
01)
Create a scene:
●
Double (24-fixture) mode – follow steps 3–8 from 6.6.1. Create a Scene in Bank A on page 21. The
concept of Bank A and Bank B is not applicable in programming mode. Therefore the
connected fixtures can be selected only with the FIXTURES buttons and faders (01)–(24).
●
Single (48-fixture) mode – follow steps 3–8 from 6.6.4. Create a Scene on page 23.
02)
Press the RECORD button (60) to start recording. The LED on the button will light up.
03)
Press one of the PLAYBACKS buttons (01)–(48) to which you want to assign the scene. The LED on the
button will start blinking.
