18
LED SPI-2 Install
Product code: 50412
6.
Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is intended for professional use as a T-bar. It is suitable only for indoor installation. This device is
not suitable for households and for general lighting.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.
Control Modes
The LED SPI-2 Install supports the following control modes:
●
Stand-alone:
Manual, Preset Colors, Built-in programs
●
DMX-512, sACN, Art-Net
17, 34, 512 channels
For more information about how to connect the devices, refer to 5. Setup on pages 13–17.
To operate the device manually as a stand-alone device:
●
Adjust the colors in Manual menu. See 6.6.4.1. User Color on page 24 for more information.
To run the preset colors without a DMX controller:
Select one of the 7 preset colors in Color Preset menu. See 6.6.4.2. Color Preset on page 24 for more
information.
To run the built-in programs without a DMX controller:
Select one of the 22 built-in programs in Program menu. See 6.6.4.3. Program on page 25 for more
information. Adjust the program speed.
To operate the device with a DMX controller:
01)
Set the DMX starting address of the device in Address menu. See 5.2.4. DMX Addressing on page 15
and 6.6.3.1. Output 1 / Output 2 on page 23.
02)
Select the DMX channel mode. See 6.6.2. Personality on page 22 for more information. See 6.7. DMX
Channels on pages 30–33 for complete overview of all DMX channels.
