SHOWTEC 43750, User Manual

Page: 29 / 52

28
Helix M1100 Q4 Mobile
Product code: 43750
6. Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is intended for professional use as an outdoor spot. It is not suitable for households and for
general lighting.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.
Turning On/Off
The device has a power switch.
● Set the power switch (10) to ON position to turn on the device.
● Set the power switch (10) to OFF position to turn off the device.
Make sure that the device is turned off from the power switch (10) when the device is not in use. This will
prevent the battery from depletion.
It is recommended to reset the device to its factory settings after each setup or use. Refer to 6.8.6.10.
Factory Reset on page 42 for more information. When you turn off the device, the next time you turn it on,
it will continue to operate in the previously selected operation mode.
Factory Reset
It is recommended to reset the device to its factory settings after each setup or use. If you do not reset
the device, the next time you turn it on, it will continue operating in the last selected operation mode.
If the device is turned off, to reset the device follow the steps below:
Set the power switch (10) to ON position to turn on the device.
Refer to 6.8.6.10. Factory Reset on page 42 for more information.