Ordercode: 43539
Spectral ZP-5
8.8. Strobe Settings
With this menu you can choose the desired strobe mode.
01)
Press the UP/DOWN buttons until the display shows
.
02)
Press the ENTER button to open the menu.
03)
Press the UP/DOWN buttons to toggle between the following 2 options:
Classic strobe
Special strobe
04)
If you have chosen
, strobe will be active only if you operate the device in one of the
following DMX channel modes/personalities: TOUR, AR2.S and TR16.
9. Calibration
With this menu, you can adjust the characteristics of the white color or set the RGB calibration.
01)
In the main menu, press the UP/DOWN buttons until the display shows
.
02)
Press the ENTER button to open the menu.
03)
Insert the password: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
04)
Press the UP/DOWN buttons to toggle between the following 3 options:
White settings
RGB calibration
Calibration reset
9.1. White color settings
With this menu you can adjust the temperature of the built-in white color presets.
01)
When the display shows
, press the ENTER button to open the menu.
02)
Press the UP/DOWN buttons to choose one of the 11 white color presets:
.
03)
Once you have chosen the desired preset, press the ENTER button to open the submenu.
04)
Press the UP/DOWN buttons to toggle between RED, GREEN, BLUE and WHITE.
05)
Press the ENTER button to open the desired color’s brightness settings.
06)
Press the UP/DOWN buttons to increase/decrease the color brightness. The adjustment range of
each color is between 0-255, from dark to brightest.
9.2. RGB calibration
With this menu you can adjust the temperature of the white color.
01)
When the display shows
, press the ENTER button to open the menu.
02)
Now you can adjust the intensity of the RGB colors. Press the UP/DOWN buttons to toggle between
RED, GREEN and BLUE.
03)
Press the ENTER button to open the desired color’s brightness settings.
04)
Press the UP/DOWN buttons to increase/decrease the color brightness. The adjustment range of
each color is between 0-255, from dark to brightest.
9.3. Calibration reset
01)
When the display shows
, press the ENTER button to open the menu.
02)
Insert the password: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
03)
The settings, which you have previously adjusted, will have been reset and the display will show OK.
20
