10
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
You can operate this device as:
1.
DMX-controllable
2.
DMX-serial Data Link
3.
Master/Slave Data Link
DMX-controllable
Link the units as shown below, Connect a DMX signal cable from the first unit's DMX "out" socket to the
second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the other
end of the mains power cord into proper electric power supply sockets, starting with the first unit.
Do not supply power before the whole system is set up and connected properly.
DMX-serial Data Link
Master/Slave Data Link
