10
Ordercode: 42512
Medium Studiobeam RGBW 3° Tour
Control Modes
There are 6 modes:
•
Built-in programs
•
Static Color Presets
•
Manual Mode
•
Sound-controlled
•
Master/Slave
•
DMX-512 (4CH, 6CH)
One Studiobeam (Built-in programs, Manual Mode and Static Colors)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
When the Studiobeam is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 15-17 for more information about the Built-in programs, Static Color Presets and
Manual mode.
One Studiobeam (Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
Turn on the music. If the device is set to sound-control, then the Studiobeam will react to the beat of
the music. Please see page 16 for more information about the sound-control options.
Multiple Studiobeams (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Use a 3-pin XLR cable to connect the Studiobeam.
03)
Set the Slave devices to 1001-1512 or 2001-2512.
The pins:
01) Earth
02) Signal -
03) Signal +
04)
Link the units as shown in fig. 04. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 15-16 (Built-in
programs, Auto Mode, Manual Mode or Sound-controlled Mode). This means that you can set your
desired operation mode on the master device and all slave devices will react the same as the
master device.
Multiple Studiobeams (Master/Slave control)
Fig. 04
Each Slave device must be set to
or
.
