8
Ordercode: 42468
Par 64 Short Q4-18
Control Modes
There are 5 modes:
●
Built-in programs
●
Auto Run
●
Sound-controlled
●
Master/Slave
●
DMX-512 (4CH, 5CH, 8CH)
One Par (Auto Mode and Built-in programs)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
When the Par is not connected with a DMX cable, it functions as a stand-alone device.
04)
See page 13–14 for more information about the Built-in programs and Auto Mode.
One Par (Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
Turn on the music. If the device is set to sound-control, then the Par will react to the beat of the
music.
04)
Please see page 13 for more information about the sound-control options.
Multiple Pars (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Use a 3-pin XLR cable to connect the Par.
The pins:
01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in Fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 13–14 (Built-in
programs, Auto Mode or Sound-controlled Mode). This means that you can set your desired
operation mode on the master device and all slave devices will react the same as the master
device.
Multiple Pars (Master/Slave control)
Fig. 03
